Players are using the new Ultra Hand ability given to us The Legend of Zelda: Tears of the Realm To make something truly wild (which may or may not violate the Geneva Convention, but that’s for another article). I hope you got some good Ultrahand practice on all your expeditions, as you’ll be testing your problem-solving skills at the Runakit Shrine in Hyrule Ridge.
The final level of this puzzle can be quite tricky, so be good at geometry. If you need help solving the puzzles at Runakit Shrine in Tears of the Kingdom, check out the guide below.
How to Complete Runakit Shrine: Built to Be Transported
coordinate |
-2530, 1170, 0178 |
---|
The Runakit Shrine itself is pretty easy to see when activating it. Lindor’s Brow Skyview Tower And I think it’s almost due West out of it when you start out. on your map north of mount roamnot far eastern Hyrule Ridge Chasm.
One of the first things you see when you enter the temple orange ball keyhole You are on the floor next to the locked door to the finish line and the ball is also in sight. You can’t even get the ball back to the beginning with an ultra hand across a big gap.
you must Use the rails around the area. Carefully Get the ball through three increasingly complex mechanisms. To revert to the first time.
to start Paragliding from the starting platform to the ball platform. when landing, climb a ladder It reaches the ball itself.
using ultra hand catch the ball simple from the starting position Place it on a nearby metal bar.. If you put it close enough to the edge, gravity will take control and send the ball to the second platform. Paragliding after the ball to go directly.
on the second platform rail is too wide So that the ball hits without falling right away. However, you will notice two straight metal rods Lean against the wall in the corner.
using ultra hand grab the rod one by one and Rotate Paste they hit the ball that way extrude horizontally on both sides of the ball.
Once this little device is made, Place the rail on the bar. with hanging ball, and it will slide into the third and final puzzle platform. again, paragliding to meet it.
The third puzzle is the most complex of all. 1 stop rail You will need to use it to get the ball back to the beginning. you have a choice Metal pieces along the back wall You can use it to get there.
For this you need to: make a crude hook Use a piece of metal lying around. It’s not a pretty shape, but it gets the job done.
Glue the 2 L-shaped pieces together. The long sides are made together. square C shape when merging. attached to this side Third L-shaped piece It almost completes a square.
Now go back to where the ball landed Shake one of the metal rods. With one rod still connected to the ball, Attach the rod to the open part of the shape. Made from 3 L-shaped pieces.
Using Ultrahand here Flip the shape so that the ball hangs in the gap. A little – otherwise it doesn’t fit.
It is helpful to move this claw shape as far down the rail as possible before releasing it. This shape also swings only on one rail.
let’s go Watch your balloon’s ball glide back the first time.
paragliding overshake the ball loosely Use the Ultrahand to bring it back to the top. We put it in the hole and finish off the Runakit Shrine.
How to get a treasure chest at Runakit Shrine
The treasure chest of Runakit Shrine on the third platformIt is above where you are making the claw shape to complete the puzzle.
Before doing so, you will find a few things lost rail to the left. you can Before building the claw device, make a rail device from pieces nearby. but the easiest way make a little bridge It’s enough to reach the platform for Link to break out of the three pieces.
waiting for you construct bow.